Woodworking Machinery
..The Equipment Experts

SCM TF2400 L'Invincibile electronic spindle moulder with
fixed shaft, electrospindle, and HSKB63 rapid tool change
Technical Specification:
- worktable dimensions with "LL" extensions 2500 x 750mm
- tool holders with HSK B 63 taper 5no.
- max height of tool-holder shaft 140mm
- tool rack for 5 tool holders 1no.
- max. tool diam. with profiling fence 250mm
- max. tool diam. retractable under the table 300 x 75mm
- exhaust hood on fence and behind the base dia 120mm
- pneumatic working pressure min. 6bar
- inverter for speed change to be selected
from control panel from 900 - 10000rpm
- electrospindle motor power 10hp
STANDARD EQUIPMENT :
- Electronic control with Windows operating system, CPU Pentium,
12"colour flat screen with touch-screen system on upper control panel
- direct control of the following working axes (4+1) with manual, semi-
automatic, automatic, incremental mode:
* vertical tool-holder shaft lifting
* movement of entire fence with reference to the tool diameter.
* infeed fence with reference to the requested removal
* "Fast" section table movement
* tool rotating speed programming according to the profile
* automatic set up
* storage capacity up to 999 working programs
- Electrospindle with maximum motor power available as from 3.000 rpm
* forced liquid cooling
* pneumatic system for rapid change of tool-holder shaft with HSK B 63 taper
* double air blower system to mantain cleaned contact surfaces , both in
taper housing and on table, to obtain the maximum coupling precision
* Safety sensors for changing tool operation: spindle rotating stop control,
tool taper locking/unlocking control
- vertical shaft movement on two linear precision guides through
preloaded recirculating ball bearing pads.
- upper mobile control panel
- the FLEX system facilitates the exclusion of the spindle fence from
worktable
- reverse spindle rotation with electrical interlocking for start up
- electronic brake on spindle ensuring stop, even in case of voltage drop.
- emergency pushbutton, padlockable main switch, overload switch protection
- automatic start for main motor
- auxiliary low voltage circuit (110 volt)
01.10.91 T 140 Vanguard-Electronic Spindle Moulder*CE Norms*
with HSK B 63 tool changer.
Certificate in conformity with "C.E. standard"