Woodworking Machinery
..The Equipment Experts

MORSO - EH Mitring machine
--------------------------------------------------------------------------------
Description:
MORSO-EH is a fully automatic electric/hydraulic mitring machine, with a noise level below 70db - the perfect machine to cut picture mouldings in production - wooden, plastic, and MDF mouldings. In principle MORS+-EH does the same work as the MORS+-F , but with the MORS+-EH you have your work done automatically by pushing two push buttons. The MORS+-EH is safe to operate as you must activate both push buttons at the same time to have the machine work, and therefore you cannot get your fingers underneath the knives. With the MORS+-EH you can do production work all day long. The MORS+-EH can be delivered either single phase or three phase with voltage to your requirements.
If you compare the MORS+-EH to a double mitre saw, you will find that first of all the cut with a saw is not as clean and accurate as with the MORS+-EH. Secondly there will very often be a problem with the dust from the saw. On MORS+-EH there is no dust, as the waste of the moulding is lead straight to the ground, which means it is not necessary to buy an expensive dust extractor. Another thing is the waste of the moulding. By using a mitre saw, there will always be about one centimetre of waste per cut, but if you see the MORS+-EH the waste is minimized to about 1 mm per cut. A difference of one centimetre may not sound of much, but if the number of cuts are 200 per day, the unnecessary waste of moulding is 200 cm per day, which is about 520 meters per year..... ( Working 5 days a week... ). If you compare the time spent per cut, the MORS+-EH normally uses 1 to 1,5 second to finish the moulding. With the saw, it is about the same, if not a little more, so even here we cannot find an advantage with the double mitre saw....
The MORS+-EH is supplied with the same standard equipment as the MORS+-F plus it has:
Extension table to the left side.
Automatic Rebate Supports and Moulding Clamps.
Measuring scale 1500 mm with two adjustable stops - you can cut the short and long lengths of a frame without having to re-adjust the measurements.
Automatic cutting cycles for both large and small mouldings - which means that the machine always does the trim cut which is very important.
Adjustable length of stroke (3 positions) - when using the lowest cutting position the cutting cycle of two cuts only takes between 1 and 1.5 seconds.
Technical data for MORS+-EH

Double mitre 45°

Single mitre up to 90°

Cutting width max. 100 mm (4 ")

Cutting height max. 180 mm (7 ")

Square cutting 70/70 mm (2 3/4")

Measuring scale up to 1500mm (59 ")

Net weight 135 kilos (298 lbs)

Motor, single phase 1.1 kW

Motor, three phase 1.1 kW

Pumping capacity 7 l/min.

Working pressure 80 bar

Power transmission 660 kilos

Tank contents 6 l.

Optional extra'
Also available with Turbo making the unit upto 50% quicker.
Packed dimensions 70 x 60 x 115, 135kg